S-clips
As a rule, S-clips are used when you can drill the support profile. This type of clip is very easy to fit. ‘The cross’ should be removed at the place where the clip is fastened. As standard, the S-clip consists of the following parts:
- 1x bolt M8 x 50/60;
- 1x plate;
- 1x ring M8;
- 1x M8 locking nut.
Quality
The S-clip is available in a variety of qualities depending on the application and environment.
- Stainless steel 316-A4: Vinylester gratings (type VE-FR, VE-XFR) for chemicals;
- Stainless steel 304-A2: Isophthalic grating (type ISO-FR and all other types) for normal corrosion-resistant outdoors and offshore-marine environments;
- Galvanised (HD): orthophthalic gratings (type ECO-NFR, ECO-FR) for all low-corrosion environments.
Standards
Fiberstruct’s mounting materials satisfy all applicable standards. You can find these in the appendices at the bottom of this page.
Height and grating mesh width
The S-clip is suitable for all types of gratings with square meshes and the heights listed below:
- 25 mm (1 inch);
- 30 mm (1.25 inches);
- 38 mm (1.5 inches).