M-clips
As a rule, M-clips are used when you can drill the support profile. This type of clip is very easy to fit. As standard, the M-clip consists of the following parts:
- 1x bolt M8 x 50/60/80;
- 1x plate M-saddle;
- 1x ring M8;
- 1x M8 locking nut.
The M-clip is optionally available with an arm to clamp the grating (see B-clips).
Quality
The M-clip is available in a variety of qualities depending on the application and environment.
- Stainless steel 316-A4: Vinylester gratings (type VE-FR, VE-XFR) for chemicals;
- Stainless steel 304-A2: Isophthalic grating (type ISO-FR and all other types) for normal corrosion-resistant outdoors and offshore-marine environments;
- Galvanised (HD): orthophthalic gratings (type ECO-NFR, ECO-FR) for all low-corrosion environments.
Standards
Fiberstruct’s mounting materials satisfy all applicable standards. You can find these in the appendices at the bottom of this page.
Height and grating mesh width
The M-clip is suitable for all types of gratings with square meshes and the heights listed below:
- 13 mm (0.5 inches);
- 25 mm (1 inch);
- 30 mm (1.25 inches);
- 38 mm (1.5 inches);
- 50 mm (2 inches).